Skip to content
Agreements
Tools

Engineering tools

Runs in your browser

Clamping Force Calculator

Size the press for an injection mold or the locking force for a die casting die from the projected area, the melt pressure and a safety factor.

ProcessThe melt pressure that tries to push the mold open differs by process.
UnitsUnits

Required clamping force

—

—

Specify a press rated at least—
Total projected area (A)
—
Pressure (P)
—
Safety factor (SF)
—

F = A × P × SF. Total projected area is the part area times the number of cavities plus the runner, overflow and biscuit area. 1 US ton = 2,000 lbf = 8.896 kN; 1 MPa = 145 psi.

Calculated in your browser; nothing is sent or stored. Typical pressures are starting points: confirm them against the material data sheet and your molder's or die caster's process sheet.

How it works

Three numbers decide the press

  1. 01

    Measure the projected area

    Project the part onto the parting plane and take that area, not the surface area. Add the runner system, and for die casting the overflows and biscuit, since the melt presses on all of it.

  2. 02

    Pick the pressure

    Choose the resin or alloy for a typical cavity or metal pressure, then override it with the value from your material data sheet or process sheet when you have one.

  3. 03

    Size the press

    The result is the force that keeps the mold shut at peak pressure. Specify a machine rated at or above the suggested tonnage so the clamp has margin for wear and shot-to-shot variation.

Sizing a mold or die for production?

hello@landiindustries.com

Talk to an engineer →